Skip to main content

Lixel OpenAPI Manual · v1.1.0 · Page 6 of 15

Project File Access

A Lixel device exposes project files in two ways:

  • HTTP: the interface responses give file URLs directly; read them with a browser or HTTP client, no file sharing needed.
  • File sharing (SMB): mount the device with a standard file-sharing client; must be enabled first.

Reading project files over HTTP

In the responses of project_list (AC_LIST_ALL_PROJECTS) and modeling_status, fields such as poses_url, control_points_url, measure_points_url, and xbin_url are HTTP URLs of the form http://<host>/static/<project>/project_data/poses.csv; for projects on external storage the path uses /udisk/.

The host in the URL is taken from the device's wireless interface address, falling back to 192.168.55.1 when unavailable (192.168.144.100 on the F1 model, per the device-side source). Over a wired connection it may be 192.168.56.1, which the host cannot reach. Measured on a Lixel L2Pro (firmware V3.2.1): over a wired connection the host returned by project_list was 192.168.56.1 and timed out; replacing the host with 192.168.55.1 returned HTTP 200. So over a wired connection, replace the host in the URL with the same address you use for MQTT before accessing it.

Enabling file sharing

The file-sharing service is off by default. Before access, send the enable action through the device control interface:

  • Enable: action: AC_START_FS
  • Disable: action: AC_STOP_FS

For the device control interface, see Interface Catalog · Device Management.

Warning: file sharing uses a fixed default credential. Anyone who knows it and can reach the device's network can access the files. Enable it only when needed and send AC_STOP_FS when done.

Connection parameters

Once enabled, mount with these parameters:

ParameterValueNote
Service addresssmb://<device_ip>/sharedevice_ip matches the MQTT connection address
UsernameadminDefault, not changeable
Passwordadmin123Default, not changeable

Note: device_ip is the same address you use for the MQTT connection (192.168.55.1 wired, or the Wi-Fi address obtained over Bluetooth for wireless).

XGRIDS documentation, reproduced as published and captured on October 27, 2026. Read this page on docs.xgrids.com

Stuck on a Step?

QRC supports every scanner and software seat it sells. Send us the page you are on and we will walk you through it.

Contact Us
Request a Quote